The main objective of this literature survey was to search for stable inhibitors that effectively prevent corrosion on aluminium in contact with heat transfer fluids at temperatures above 100 °C, preferably above 130 °C. The corrosion behaviour of aluminium is mostly dependent of the surface film of aluminium oxide, for it is the properties of this film that provide aluminium with its resistance to corrosion. When a fresh aluminium surface is created and exposed to air, it oxidizes rapidly, and acquires a compact, adherent, protective film of aluminium oxide which tends to resist further oxidation. On a freshly rolled aluminium sheet the film is extremely thin about 0.01 um. When aluminium is immersed in water, the oxide film thickens rapidly, at a rate that increases with temperature. It is commonly stated that the oxide film is stable over a pH range of about 4.5 to 8.5. But there are exceptions. Light gauge aluminium solar heat collector panels operating on aqueous glycol heat transfer fluids appear to be attractive except for the critical problem of aluminium corrosion. The corrosion resistance of aluminium is marginal even in pure uninhibited ethylene glycol solutions up to 100 °C. However, this marginal corrosion resistance is enormously reduced in the presence of chloride or heavy metal ions (e.g. Cu2+ and Fe3+). A similar conclusion was reached for aluminium/propylene glycol combinations. It was found that inhibitors used in commercial automotive coolants are effective only at temperatures below 100 °C, and that pitting corrosion induced by chloride and heavy metal ions reappears at higher temperatures. But the combined use of zinc powder and conventional corrosion inhibitors compatible with aqueous glycol solutions is 100 % effective in stopping all aluminium corrosion problems at temperatures up to 130 °C, even in solutions initially containing chloride and heavy metal ions.
SP Rapport 1989:18