Endre søk
RefereraExporteraLink to record
Permanent link

Direct link
Referera
Referensformat
  • apa
  • harvard1
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annet format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annet språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
The effect of initial grain size and temperature on the tensile properties of magnesium alloy AZ31 sheet
Deakin University.
Deakin University.
RISE, Swerea, Swerea KIMAB AB.
2012 (engelsk)Inngår i: Materials Science & Engineering: A, ISSN 0921-5093, E-ISSN 1873-4936, Vol. 549, s. s.1-6Artikkel i tidsskrift (Fagfellevurdert)
Abstract [en]

This research aimed to assemble and review data that are relevant to sheet metal formability of the magnesium alloy AZ31. Rolled sheets were processed to give four different grain sizes in the range from 2.9 to 47.1 μm. Similar basal textures were present in all these conditions. Tensile tests were carried out at various temperatures between 25 °C and 240 °C, with some additional tests also made below room temperature in dry ice. Results are presented and discussed relating to strength, ductility, strain rate sensitivity and anisotropy. An optimum grain size of about 7 μm applies for ductility over most of the temperature interval. Uniform elongation decreases steadily with increasing temperature whereas the post-necking and total elongation values increase markedly. Measurements of strength, anisotropy and strain rate sensitivity all indicate a significant role of grain boundary mediated deformation above room temperature. The plastic strain ratio, r, is high at room temperature but decreases considerably, especially for the fine grained conditions, at higher temperatures. Modifications to the active slip modes also occur over the same temperature interval but their effect on plasticity is probably less important than was previously believed. © 2012 Elsevier B.V.

sted, utgiver, år, opplag, sider
2012. Vol. 549, s. s.1-6
Emneord [en]
Magnesium alloys, Plastic anisotropy, Strain rate sensitivity, Tensile properties
HSV kategori
Identifikatorer
URN: urn:nbn:se:ri:diva-12835DOI: 10.1016/j.msea.2012.03.107Scopus ID: 2-s2.0-84861346952OAI: oai:DiVA.org:ri-12835DiVA, id: diva2:973028
Tilgjengelig fra: 2016-09-22 Laget: 2016-09-22 Sist oppdatert: 2017-11-21bibliografisk kontrollert

Open Access i DiVA

Fulltekst mangler i DiVA

Andre lenker

Forlagets fulltekstScopushttp://www.sciencedirect.com/science/article/pii/S0921509312005163
Av organisasjonen
I samme tidsskrift
Materials Science & Engineering: A

Søk utenfor DiVA

GoogleGoogle Scholar

doi
urn-nbn

Altmetric

doi
urn-nbn
Totalt: 66 treff
RefereraExporteraLink to record
Permanent link

Direct link
Referera
Referensformat
  • apa
  • harvard1
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annet format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annet språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
v. 2.35.8