Endre søk
RefereraExporteraLink to record
Permanent link

Direct link
Referera
Referensformat
  • apa
  • harvard1
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annet format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annet språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
Evaluation of cyclone gasifier performance for gasification of sugar cane residue: Part 1: Gasification of bagasse
RISE., SP – Sveriges Tekniska Forskningsinstitut, SP Energy Technology Center.ORCID-id: 0000-0002-1757-9456
2001 (engelsk)Inngår i: Biomass and Bioenergy, ISSN 0961-9534, E-ISSN 1873-2909, Vol. 21, nr 5, s. 351-369Artikkel i tidsskrift (Fagfellevurdert) Published
Abstract [en]

A method for avoiding excessive amount of alkali compounds and carryover particles in producer gas from gasification of sugar cane residue has been studied and evaluated. The cane sugar residue is gasified in a two-stage combustor at atmospheric pressure, where the first stage is a cyclone gasifier. The cyclone works as particle separator as well. This paper covers the results obtained for gasification of bagasse. Bagasse powder was injected into the cyclone with air and steam as transport medium. The gasification tests were made with two feeding rates, 39 and 52 kg/h. Seven experiments were conducted with the equivalence ratio being varied. The heating values of the producer gas are sufficient for stable gas turbine combustion. About 60-70% of the alkali input with fuel was separated from the producer gas in the cyclone. However the total alkali contents of the producer gas was found to be higher than in ABB Stal PFBC gas turbines and at least an order of magnitude higher than what is required by most gas turbine manufacturers for operation of a gas turbine. The carryover particles concentrations in the producer gas were found to be in the range of that for PFBC gas turbines, but higher than what is required by most gas turbine manufacturers for operation of a gas turbine. Samples studied with scanning electronic microscope give indication that most of the carryover particles are below 10 μm in size. Fly ash-melting tests have not shown any major ash melting up to 1200°C, but it was found that some of the particles entrained with producer gas were partially melted. Integrated experiments with a gas turbine need to be done for accurate evaluation of the possibilities to use the producer gas from the gasification of bagasse to run a gas turbine without problems of hard deposits and corrosion on the turbine blades. In part 2 of this two-part paper the results from cane trash gasification tests are reported. © 2001 Published by Elsevier Science Ltd.

sted, utgiver, år, opplag, sider
2001. Vol. 21, nr 5, s. 351-369
Emneord [en]
Alkali, Bagasse, Corrosion, Erosion, Fly ash, Gasification, Heating value, Particles, Producer gas
Emneord [sv]
Energiteknik
HSV kategori
Identifikatorer
URN: urn:nbn:se:ri:diva-6999DOI: 10.1016/S0961-9534(01)00043-5Scopus ID: 2-s2.0-0034776142OAI: oai:DiVA.org:ri-6999DiVA, id: diva2:964854
Tilgjengelig fra: 2016-09-08 Laget: 2016-09-08 Sist oppdatert: 2019-06-24bibliografisk kontrollert

Open Access i DiVA

Fulltekst mangler i DiVA

Andre lenker

Forlagets fulltekstScopus

Personposter BETA

Pettersson, Esbjörn

Søk i DiVA

Av forfatter/redaktør
Pettersson, Esbjörn
Av organisasjonen
I samme tidsskrift
Biomass and Bioenergy

Søk utenfor DiVA

GoogleGoogle Scholar

doi
urn-nbn

Altmetric

doi
urn-nbn
Totalt: 21 treff
RefereraExporteraLink to record
Permanent link

Direct link
Referera
Referensformat
  • apa
  • harvard1
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annet format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annet språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
v. 2.35.8